CC40106由六个斯密特触发器电路组成。每个电路均为在两输入端具有斯密 特触发器功能的反相器。触发器在信号的上升和下降沿的不同点开、关。上升电压(V T+)和下降电压(V T-)之差定义为滞后电压。
CD40106引脚图
引脚功能：
2 4 6 8 10 12 数据输出端
1 3 5 9 11 13 数据输入端
14 电源正
7 接地
CD40106内部图
Absolute Maximum Ratings 绝对最大额定值：
| DC Supply Voltage 直流供电电压 (VDD) | −0.5 to +18 VDC |
| Input Voltage输入电压 (VIN) | −0.5 to VDD +0.5 VDC |
| Storage Temperature Range储存温度范围 (TS) | −65℃ to +150℃ |
| Power Dissipation功耗 (PD) | |
| Dual-In-Line 普通双列封装 | 700 mW |
| Small Outline 小外形封装 | 500 mW |
| Lead Temperature 焊接温度(TL) | |
| Soldering, 10 seconds)（焊接10秒） | 260℃ |
Recommended Operating Conditions 建议操作条件：
| DC Supply Voltage 直流供电电压 (VDD) | 3 to 15 VDC |
| Input Voltage输入电压 (VIN) | 0 to VDD VDC |
| Operating Temperature Range工作温度范围 (TA) | −55℃ to +125℃ |
DC Electrical Characteristics 直流电气特性：
|
Symbol 符号 |
Parameter 参数 |
Conditions条件 |
−55℃ | +25℃ | +125℃ |
Units 单位 |
||||||
| 最小 | 最大 | 最小 | 典型 | 最大 | 最小 | 最大 | ||||||
| IDD | Quiescent Device Current静态电流 | VDD = 5V | 1.0 | 1.0 | 30 | μA | ||||||
| VDD = 10V | 2.0 | 2.0 | 60 | |||||||||
| VDD = 15V | 4.0 | 4.0 | 120 | |||||||||
| VOL | LOW Level Output Voltage 输出低电平电压 | VDD =5V VDD=10V VDD=15V | |IO|<1μA | 0.05 0.05 0.05 | 0.05 0.05 0.05 | 0.05 0.05 0.05 | V | |||||
| VOH | HIGH Level Output Voltage 输出高电平电压 | VDD=5V | |IO|<1μA | 4.95 | 4.95 | 5 | 4.95 | V | ||||
| VDD=10V | 9.95 | 9.95 | 10 | 0.95 | ||||||||
| VDD=15V | 14.95 | 14.95 | 15 | 14.95 | ||||||||
| VT− | Negative-Going Threshold Voltage 负向阈值电压 | VDD=5V,VO=4.5V | 0.7 | 2.0 | 0.7 | 1.4 | 2.0 | 0.7 | 2.0 | V | ||
| VDD=10V,VO =9V | 1.4 | 4.0 | 1.4 | 3.2 | 4.0 | 1.4 | 4.0 | |||||
| VDD=15V,VO=13.5V | 2.1 | 6.0 | 2.1 | 5.0 | 6.0 | 2.1 | 6.0 | |||||
| VT+ | Positive-Going Threshold Voltage 正向阈值电压 | VDD=5V,VO=0.5V | 3.0 | 4.3 | 3.0 | 3.6 | 4.3 | 3.0 | 4.3 | V | ||
| VDD=10V,VO =1V | 6.0 | 8.6 | 6.0 | 6.8 | 8.6 | 6.0 | 8.6 | |||||
| VDD=15V,VO=1.5V | 9.0 | 12.9 | 9.0 | 10.0 | 12.9 | 9.0 | 12.9 | |||||
| VH | Hysteresis (VT+ − VT−) Voltage滞后VT+ − VT−)电压 | VDD = 5V | 1.0 | 3.6 | 1.0 | 2.2 | 3.6 | 1.0 | 3.6 | V | ||
| VDD = 10V | 2.0 | 7.2 | 2.0 | 3.6 | 7.2 | 2.0 | 7.2 | |||||
| VDD = 15V | 3.0 | 10.8 | 3.0 | 5.0 | 10.8 | 3.0 | 10.8 | |||||
| IOL | LOW Level Output Current 输出低电平电流(Note 3) | VDD=5V,VO=0.4V | 0.64 | 0.51 | 0.88 | 0.36 | mA | |||||
| VDD=10V,VO=0.5V | 1.6 | 1.3 | 2.25 | 0.9 | ||||||||
| VDD=15V,VO=1.5V | 4.2 | 3.4 | 8.8 | 2.4 | ||||||||
| IOH | HIGH Level Output Current 输出高电平电流 (Note 3) | VDD=5V,VO =4.6V | −0.64 | −0.51 | −0.88 | −0.36 | mA | |||||
| VDD=10V,VO=9.5V | −1.6 | −1.3 | −2.25 | −0.9 | ||||||||
| VDD=15V,VO=13.5V | −4.2 | −3.4 | −8.8 | −2.4 | ||||||||
| IIN | Input Current 输入电流 | VDD=15V,VIN =0V | −0.1 | −10−5 | −0.1 | −1.0 | μA | |||||
| VDD=15V,VIN=15V | 0.1 | 10−5 | 0.1 | 1.0 | ||||||||
AC Electrical Characteristics 交流电气特性：
|
Symbol 符号 |
Parameter 参数 | Conditions 条件 | 最小 | 典型 | 最大 | Units 单位 |
| tPHL or tPLH | Propagation Delay Time from Input to Output 输入输出传播延迟时间 | VDD = 5V | 220 | 400 | ns | |
| VDD = 10V | 80 | 200 | ||||
| VDD = 15V | 70 | 160 | ||||
| tTHL or tTLH | Transition Time过渡时间 | VDD = 5V | 100 | 200 | ns | |
| VDD = 10V | 50 | 100 | ||||
| VDD = 15V | 40 | 80 | ||||
| CIN | Average Input Capacitance 平均输入电容 | Any Input | 5 | 7.5 | pF | |
| CPD | 功耗容量 | Any Gate (Note 5) | 14 | pF |
典型应用电路：
|
切换时间波形： |
 |
|
|
